Why Texas A/S BC358D engine will not reach full speed and produces a lot of smoke?
If your Texas A/S Trimmer engine won't reach full speed and is producing a lot of smoke, start by checking the fuel. Using new fuel might solve the problem. Also, a dirty air filter can cause this issue, so try cleaning or replacing it. If these steps don't work, the carburetor may need adjustment, and it's best to contact a repair shop for that.
What to do if the cord cannot be extended on a Texas A/S BC358D?
If the cord on your Texas A/S Trimmer cannot be extended, it could be due to several reasons. The cord may have melted, in which case you should replace it. Alternatively, there might not be enough cord on the spool, so you should fit more cord. It's also possible that the cord is worn down; try advancing the cord while pressing and releasing the cord housing. If the cord is tangled with the spool, remove it and roll it back on. Lastly, if the engine RPM is too low, try advancing the cord at full throttle.
What to do if Texas A/S BC358D engine starts, but will not accelerate?
If the Texas A/S Trimmer engine starts but won't accelerate, the carburetor likely needs adjustment. It is best to contact a repair shop for this.
Why Texas A/S BC358D Trimmer starts, but will only run at full throttle with half choke?
If your Texas A/S Trimmer engine starts but only runs at full throttle with half choke, the carburetor likely needs adjustment, repair, or cleaning. It's recommended to contact a repair shop for this.
Why is grass getting twisted around drive shaft and cord housing on my Texas A/S Trimmer?
If grass is getting twisted around the drive shaft and cord housing of your Texas A/S Trimmer, it could be because you're cutting high grass at ground level; try cutting the grass from top to down. Another reason might be using the trimmer at low RPM; try using it at high RPM.
What causes a Texas A/S BC358D engine to start, run, and accelerate, but not run in idle?
If the Texas A/S Trimmer engine starts, runs, and accelerates, but won't run in idle, the carburetor likely needs adjustment. Contact a repair shop for assistance.
How to fix a Texas A/S BC358D Trimmer cord spool that is hard to turn?
If the cord spool on your Texas A/S Trimmer is hard to turn, the threads may be dirty, damaged, or full of grass. Try cleaning the threads and lubricating them with grease. If necessary, replace the spool.
How to troubleshoot a Texas A/S Trimmer that will not start?
If the Texas A/S Trimmer engine won't start, several factors could be at play. First, there might be no spark. To address this, inspect the spark plug: remove it, keep it connected to the lead, and place it against the cylinder block. Then, pull the starter cord to check for a spark. If none appears, try again with a new spark plug. Another possibility is a lack of fuel. Try pressing the fuel pump button. If the issue continues, it's best to contact a dealer or repair shop. Alternatively, the engine may be flooded. In this case, remove the spark plug and turn the trimmer over, pointing the spark plug hole downward. Set the choke to "Run" and pull the starter cord 10–15 times. Clean the spark plug, screw it back in (or replace if necessary), and then pull the starter cord 3 times with the c...
To Next Page
General
