Texas Instruments MC-780PIx - Using External SYNC Mode; External Sync With Interlace; External Sync With No Interlace

3-1
Using the External SYNC Mode
Using the External SYNC Mode
The camera can be synchronized externally by inputting an external sync sig-
nal. When using external sync, set the clock board’s sync signal input/output
switch (SW1) to the external sync signal in (upper switch position) and
switches 3 and 4 to the mode switch (SW3), located on the rear panel, to ON.
Topic Page
3.1 External Sync With Interface 3-2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3.2 External Sync With No Interface 3-3. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Chapter 3