Texas Instruments TI-99/4A - HOOKING UP YOUR TI-99;4 A

Place the computer console on a firm surface,
with room for any accessories that you may
have purchased. If you are using a television set
as a monitor, you'll need a screwdriver to con
nect the computer to it. Unwrap the books in
the cellophane wrapper. Between them you'll
find some papers;you'll also find some strips of
plastic (gray on the front and black on the back).
These plastic strips are called overlays.
One of
the strips has some writing on it; place that strip
on the computer console in the angled space
just above the keyboard.
Pick up the Power Supply that was packed with
your computer. Insert the four-pin plug at the
end of the Power Supply cable into the four-pin
connector on the left rearof the computer. Plug
the Power Supply into a standard 115-voltAC
electrical outlet. As a safety precaution, you may
want to unplug the Power Supply when you fin
ish using the computer (and replug it the next
time).
To link your computer to a television follow
these steps:
16