Texas Instruments TI-99/4A - Page 192

STEP 7
The message
*PRESS CASSETTE STOP CS1
THEN PRESS ENTER
appears on the screen. So push the STOP button
on yourcassette recorder and then the ENTER
key on the computer console.
BravolYou have loaded a program into your
computer.
If, instead of the *DATAOK message, you got a
message which said
*ERROR = NO DATA FOUND
PRESS R TO READ
PRESS E TO EXIT
or
*l/0 ERROR 56
something is amiss.
If no data was found, you may have put the
tape in upsidedown or you may have used a
blank tape by mistake. Examine the tape. Then
replace it correctlyinto
the recorder, close the
lid, push the PLAY button on the cassette
recorder, and press the R key on the computer
console. Now go back to STEP 6.
191