Switching on and off
Press and hold the POWER button (item 1 in Fig.) for a few seconds until the
screen saver appears, accompanied by an audible signal. To completely turn off the
device, press and hold POWER.
1) Insert the memory card into the slot (item 6 in Fig.);
Getting Started
WARNING! Check card marking before buying! For the proper operation, the
DVR requires the memory cards marked CLASS 6 and above. MicroSDXC memory
cards are supported in an experimental mode.
The company teXet Global SE is not responsible for low-quality memory cards.
Note: check if the card is not blocked (switch on the memory card must be in the
LOCK position).
a) Insert the memory card effortlessly until it clicks;
b) If the device cannot initialize the memory card or the le system on it is not op-
timal, you may need to format it on the device (in this case, all data on the memory
card will be deleted).
2) Connect the mount to the connector (item 3 in Figure);
5 USB connector
6 Memory Card slot
7 Button to start recording (REC), button to conrm the action in the
menu (OK)
8 Mode switch (MODE)
9 Up/down scroll (UP/DOWN)
10 Speaker
11 LEDs
12 Lens
13 Reset button (RESET)
14 Video connector HDMI
ENG
3
DVR.indd 3 16.01.2014 13:31:31
To Next Page
Loading...