texet DVR-3GP - Page 6

To Next Page

To Previous Page

2) To switch between les, use UP/DOWN buttons;

Note: Photos are displayed on the entire screen without any icons/panels.

3) To view video, press REC/OK;

4) To return to the list of les (6 les in the screen), press MODE.

Menu settings mode

To switch over between modes, use the MODE button;

1) To switch over between the menu items, use UP/DOWN buttons;

2) To make changes to the parameter settings, use the REC/OK button;

3) To save the changes and exit the menu, use the MODE button.

Resetting the device

If the DVR does not start, does not react to your actions, try to restart it by press-

ing the «Reset».

Firmware

ATTENTION! Correct work after the rmware can only be in compliance with all

regulations.

It is prohibited:

1) Perform the rmware upgrade of the uncharged device;

2) Stop and restart the device, disconnect the power adapter/remove the battery

during the rmware upgrade;

3) Install the software downloaded from other than the ofcial website of the man-

ufacturer;

4 ) Apply the update software, patches overclocking the CPU or the memory unit.

If you are not sure in your abilities, refer to an authorized service center to up-

grade the unit rmware. SC list is available at the manufacturer’s address

http://www.texet.eu.

WARNING! The company teXet Global SE is not responsible for the unauthorized

unit rmware upgrade. Unauthorized rmware upgrade is a reason for denying the

warranty. All les spread on the ofcial website are for use by authorized service

centers with all necessary equipment, additional software, as well as experience

and expertise.

Update process

For rmware, a memory card compatible with the model of DVR is needed.

1) Charge the register (at least the rst division on the battery icon on the screen);

2) Reset «default» setup in the DVR menu;

3) Download the rmware le from the ofcial site http://www.texet.eu;

4) Copy the rmware le texet.bin to the memory card root;

5) Insert the memory card into the register and turn it on;

6) You will see an icon with animation in a circle - wait until the installation is n-

ished; the register will turn off automatically;

ENG

DVR.indd 5 16.01.2014 13:31:32