12
Operation
Electric shock hazard:
Contact with live circuits could result in severe injury or death.
Electric shock hazard:
Do not contact the test lead tips while the continuity function (20 Ω) is selected.
Failure to observe this warning could result in severe injury or death.
1. Set the selector to the proper setting and connect the test leads to the meter.
2. See “Typical Measurements” for specific measurement instructions.
3. Test the unit on a known functioning circuit or component.
If the unit does not function as expected on a known functioning circuit, replace the batteries •
and/or fuse.
If the unit still does not function as expected, send the unit to Greenlee for repair.•
4. Take the reading from the circuit or component to be tested.
To Next Page
Loading...
