Textron Greenlee ALUMINUM SITE-RITE Series User Manual

INSTRUCTION MANUAL
ALUMINUM SITE-RITE
®
HAND BENDERS
840A, 841A, 842A, 843A,
840AH, 841AH and 842AH
AND
IRON SITE-RITE
®
HAND BENDERS
840F, 841F, 842F, 843F,
840FH, 841FH, and 842FH
Read and understand this material
before operating or servicing this
equipment. Failure to understand how to
safely operate this tool could result in an
accident causing serious injury or death.
52034125 © 2008 Greenlee Textron Inc. 4/08

Textron Greenlee ALUMINUM SITE-RITE Series Specifications

General

Brand	Textron
Model	Greenlee ALUMINUM SITE-RITE Series
Category	Construction Equipment
Language	English

Summary

Bending Techniques

Bending - Handle Up

Instructions for bending conduit with the bender handle in the upward position.

Bending - Handle Down

Instructions for bending conduit with the bender handle in the downward position.

Conduit Marking

Marking the Conduit for 90° Stubs

Steps to mark conduit accurately for creating 90-degree stub bends.

Bend Corrections and Special Bends

Correcting Overbends

Method to adjust conduit that has been bent beyond the desired angle.

Back-to-Back 90° Stubs

Procedure for creating two 90-degree bends consecutively.

Offset Bends

Offset Bend Principles

Explanation of offset bends and factors affecting their creation.

Greenlee Offset Table

Table providing multipliers and shrink per inch for offset bends.

Obstruction Navigation

Working Toward an Obstruction

Guidance on bending conduit when approaching an obstruction.

Greenlee Speed Guide for Offsets

Reference guide for offset bending calculations.

3-Bend Saddles

3-Bend Saddle Procedure

Steps and principles for creating 3-bend saddles.

Table for 45° Saddles

Table detailing measurements for 45-degree 3-bend saddles.