©2016 Copyright Kappers Fabricating, Inc. All rights reserved
Figure 5
Figure 6
1
4
1
5. Set the spacer plate (2) between the frame of the
machine and the mount (1). Shown in Figure 6.
6. Bolt the rear of the plow mount (1) up to the frame
into the OEM holes usings the two bolts (4). Shown
in Figures 5 & 6.
7. Tighten all hardware down.
8. See ATV Plow Tube System instruction manual for
tube attachment.
D
2
4
To Previous Page
Loading...