Textron STAMPEDE 900 User Manual

TEXTRON STAMPEDE 900
PLOW MOUNT
Plow Mount PART # 105815
Hardware Kit: HK-173
Kit Components:
INSTALLATION INSTRUCTIONS:
Note: Make sure all of the hardware needed to complete this
mount are in the package. Read through and understand the
instructions before installing.
1. Remove the two bolts (A) and four bolts (B) from
the factory holes in the bottom of the front lower
bumper plate. Shown in Figure 2.
2. Line the clips (C) with the OEM holes on the skid
plate (D). Shown on Figure 3.
3. Set the skid plate (D) on the the plow mount (1)
Shown on Figure 3.
4. Place the mount assembly back up to the bumper
and re-attach it using the four included ange bolts
(3). Shown in Figure 4.
Item # Qty. Description
1 1
Plow Mount
2 1
Spacer Plate
3 4
M10-1.50 X 35mm Hex Flange Bolt
4 2
M10-1.50 X 60mm Hex Flange Bolt
©2016 Copyright Kappers Fabricating, Inc. All rights reserved
Figure 1
1
3
4x
4
2x
2
A
Figure 2
B
D
Figure 3
C
D
1
Figure 4
3

Textron STAMPEDE 900 Specifications

General

Brand	Textron
Model	STAMPEDE 900
Category	Racks & Stands
Language	English

Summary

Plow Mount Installation Instructions

Prepare Bumper Plate

Remove factory bolts from the bottom of the front lower bumper plate.

Align Skid Plate

Line the clips with the OEM holes on the skid plate.

Position Skid Plate on Mount

Set the skid plate onto the plow mount.

Attach Mount Assembly

Place mount assembly to bumper and re-attach using flange bolts.

Install Spacer Plate

Set the spacer plate between the machine frame and the mount.

Secure Rear Mount

Bolt the rear of the plow mount to the frame using two bolts.

Final Tightening

Tighten all hardware down securely.

Tube Attachment Reference

Refer to ATV Plow Tube System manual for tube attachment.