25
TOGGLING AND RESETTING THE OUTDOOR DATA
1. To toggle between the outdoor current, MAX/MIN temperature data
and the times (for temperature data only) they were recorded press
the OUT/+ key:
Once to show the MAX outdoor temperature data with the
recorded time and date.
Twice to show the MIN outdoor temperature data with the
recorded time and date.
Three times to return to the current displayed values.
2. Once the MIN or MAX data is displayed, press and hold the SET
key for 3 seconds to reset the respective MIN or MAX record to
current temperature data, and current time, date display.
Note: The MIN or MAX data needs to be reset individually.
ABOUT THE OUTDOOR TRANSMITTER
The range of the Temperature transmitter may be affected by the
temperature. At cold temperatures the transmitting distance may be
decreased. Please bear this in mind when positioning the transmitters.
Also the batteries may be reduced in power for the Temperature
transmitter.
CHECKING FOR 433MHz RECEPTION
If the outdoor temperature data is not being received within three
minutes after setting up (or outdoor display show “- -. -” in the outdoor
section of the Weather station after 3 failed attempts during normal
operation), please check the following points:
1. The distance of the Weather station or transmitters should be at
least 2 meters away from any interfering sources such as computer
monitors or TV sets.
2. Avoid placing the transmitters onto or in the immediate proximity of
metal window frames.
3. Using other electrical products such as headphones or speakers
operating on the 433MHz-signal frequency may prevent correct
signal transmission or reception. Neighbors using electrical devices
operating on the 433MHz-signal frequency can also cause
interference.
Note:
When the 433MHz signal is received correctly, do not re-open the battery
cover of either the transmitter or Weather station, as the batteries may
spring free from the contacts and force a false reset. Should this happen
accidentally then reset all units (see “Setting up” above) otherwise
transmission problems may occur.
The transmission range is around 100 meters from the Temperature
transmitter to the Weather Station (in open space). However, this depends
on the surrounding environment and interference levels. If no reception is
possible despite the observation of these factors, all system units have to
be reset (see “Setting up” above).
POSITIONING THE WEATHER STATION:
The Weather Station provides the option of table
standing or wall mounting the unit. Before wall
mounting, please check that the outdoor
temperature(s) can be received from the desired
location(s). To wall mount:
1. Fix a screw (not supplied) into the desired wall,
leaving the head extended out by about 5mm.
2. Remove the stand from the Weather Station by
pulling it away from the base and hang the
To Next Page
Loading...
