26
station onto the screw. Remember to ensure
that it locks into place before releasing.
POSITIONING THE OUTDOOR TEMPERATURE
TRANSMITTER
The Outdoor Temperature transmitter is supplied with a holder and three
screws for wall mounting. Before securing the transmitter, ensure that the
433MHz signal (outdoor temperature) is properly received.
The mounting surface can affect the transmission
range. If e.g. the unit is attached to a piece of metal,
it may either reduce or increase the transmitting
range. For this reason, we recommend not placing
the unit on any metal surfaces or in any position
where a large metal or highly polished surface is in
the immediate proximity (garage doors, double
glazing etc.). Before securing in place, please
ensure that the Weather station can receive the
signal from the Outdoor Temperature transmitter at the positions that you
wish to situate them.
CARE AND MAINTENANCE:
• Extreme temperatures, vibration and shock should be avoided as
these may cause damage to the units and give inaccurate forecasts
and readings.
• When cleaning the display and casings, use a soft damp cloth only.
Do not use solvents or scouring agents as they may mark the LCD
and casings.
• Do not submerge the units in water.
• Immediately remove all low powered batteries to avoid leakage and
damage. Replace only with new batteries of the recommended type.
• Do not make any repair attempts to the units. Return it to their
original point of purchase for repair by a qualified engineer. Opening
and tampering with the units may invalidate their guarantee.
• Do not expose the units to extreme and sudden temperature
changes, this may lead to rapid changes in forecasts and readings
and thereby reduce their accuracy.
SPECIFICATIONS:
Temperature measuring range:
Indoor : -9.9ºC to +59.9ºC with 0.1°C resolution
+14.2ºF to +139.8ºF with 0.2ºF resolution
(“OF.L” displayed if outside this range)
Outdoor : -29.9ºC to +69.9ºC with 0.1°C resolution
-21.8ºF to +157.8ºF with 0.2ºF resolution
(“OF.L” displayed if outside this range)
Indoor humidity range : 1% to 99% with 1% resolution
(Display “- -“ if outside this range or
temperature is OF.L)
Indoor temperature checking intervals : Every 15 seconds
Indoor humidity checking intervals : Every 20 seconds
Air pressure checking interval : Every 15 seconds
Outdoor temperature checking interval : Every 5 minutes
Transmission range : up to 100 meters (open space)
Power consumption: (alkaline batteries recommended)
Weather Station : 2 x AA, IEC LR6, 1.5V
Transmitter : 2 x AAA, IEC LR3, 1.5V
Dimensions (L x W x H):
Weather Station : 99 x 32.3 x 220mm (stand excluded)
Transmitter : 40 x 22 x 128mm (wall bracket excluded)
To Next Page
Loading...
