2726
Radio-controlled alarm clock
• During night-time, the atmospheric interference is usually less
severe and reception is possible in most cases. A single daily recep-
tion is adequate to keep the accuracy deviation under 1 second.
5. Operation
5.1 Manual settings
• Press and hold the + or – button in setting mode for fast mode.
• The device will automatically quit the setting mode if no button is
pressed for 20 seconds.
5.1.1 Setting of the time and date
• Press and hold the TIME button in normal mode for three seconds.
• 24H (default) will be flashing. Press the + or – button to choose 12
Hr or 24 Hr system. In the 12-hour system AM or PM (after 12
o'clock) appears on the display.
• Press the TIME button to make the settings in the following
sequence: The time zone (00 - default), the hours, the minutes, the
month/day sequence D/M or M/D (D/M - default), the year, the
month, the day and the weekday (GE - default). Press the + or –
button to adjust it.
• Confirm the setting with the TIME button.
Radio-controlled alarm clock
• The manually set time is overwritten once the DCF time signal is
successfully received.
5.1.1.1 Time zone setting
• You can make the time zone correction (+12/-12) in setting mode.
• The time zone correction is needed for countries where the DCF
signal can be received but the time zone is different from the DCF
time (e.g. +1=one hour plus).
5.1.1.2 Day-of-the week language
• You can set the day-of-the week language in setting mode: German
(GE - default), French (FR), Spanish (SP), Italian (IT), Dutch (DU),
Danish (DA) and English (EN).
5.1.2 Temperature unit setting
• Press the – button in normal mode to change between °C (Celsius)
or °F (Fahrenheit) as temperature units.
6. Alarm time setting
• Press and hold the ALARM button for three seconds to enter the
setting mode.
TFA_No. 60.2547_Anleitung_11_19 14.11.2019 19:17 Uhr Seite 14
To Next Page
Loading...
