Why is my TGI Water Filtration System producing water slowly?
Slow water production in your TGI Water Filtration System can occur due to several reasons: * Low water pressure: Consider adding a booster pump. * Crimps in the tubing: Ensure that all tubing is straight and free of kinks. * Clogged prefilters: Replace the prefilters. * Fouled membrane: Replace the membrane.
What to do if water from TGI Water Filtration System tastes or smells bad?
If the water from your TGI Water Filtration System has an offensive taste or smell, the following could be the cause: * The post carbon filter is depleted: Replace the post carbon filter. * The membrane is fouled: Replace the membrane. * Sanitizer was not completely flushed out: Drain the storage tank and refill it overnight.
Why is my TGI Water Filtration System leaking?
Leaks in your TGI Water Filtration System can be attributed to: * Fittings not tightened properly: Tighten the fittings as necessary. * A twisted O-ring: Replace the O-ring. * Misalignment of the hole in the drain saddle: Realign the drain saddle.
What to do if there is a noise from the faucet of my TGI Water Filtration System?
The noise from the faucet in your TGI Water Filtration System could be due to: * Air gap faucet: The noise should disappear after the system shuts down. * Location of the drain saddle: Relocate the drain to above the water trap. * Restriction in the drain line: Check for blockages, which are sometimes caused by debris from the garbage disposal or dishwasher.
What to do if my TGI Water Filtration System produces a small amount of water?
A small amount of water from the storage tank of your TGI Water Filtration System can be due to: * The system is just starting up: It normally takes 2-3 hours to fill the tank. * Low air pressure in the storage tank: Add pressure to the storage tank. The pressure should be 8-10 psi when the tank is empty.
Why is the water from my TGI Water Filtration System milky colored?
Milky colored water from your TGI Water Filtration System is typically due to air in the system. This is a normal occurrence during the initial startup of the RO system and should disappear with normal use within 1 to 2 weeks.
What to do if there is no drain water from my TGI Water Filtration System?
If there is no drain water from your TGI Water Filtration System, the flow restrictor may be clogged. Replace the flow restrictor to resolve this issue.
General| Model | TGI-315 |
|---|---|
| Model Number | TGI-315 |
| Category | Water Filtration Systems |
| Operating Temperature | 40-100°F |
| Flow Rate | 15 GPM |
| Filter Media | Activated Carbon |
| Dimensions | 10" x 54" |
To Next Page
