Thames GECKOBOT - Kit Contents

No. Description Qty. Item No.
 Short anchor pin (yellow) 
WCY
 Anchor pin (orange) 
WCO
 Joint pin 
WAR
 Tube bolt 
WGO
 Tube bolt cap 
WFO
 Shaft plug 
WHY
 Shaft pin 
WJR
 Two-to-one converter 
WGTB
 Long button pin 
WETY
 Tube,  mm 
WGD
 -hole wide rounded rod 
WCG
 Curved rod (dark green) 
WVG
 Curved rod (light green) 
WVG
 -hole dual rod C 
WSG
 -hole rod B 
WKG
 -hole flat rounded rod (light green) 
WCG
 -hole flat rounded rod (dark green) 
WCG
 -hole wide rounded rod 
WCG
 -hole rod 
WCG
 Square frame 
WTG
 Axle,  mm 
WOD
No. Description Qty. Item No.
 Axle,  mm 
WMD
 Axle,  mm 
WQD
 Small gear 
WDS
 Angled arm 
WBG
 Triangular bracket 
WKG
 Tube,  cm 
W
 Anchor pin lever 
WBY
 Tube connector cap 
WFR
 -hole crank (dark green) 
WHG
 -hole crank (light green) 
WHG
 Small cam (pear shape) 
WGR
 Large cam (teardrop shape) 
WGR
 -hole -degree converter 
WIG
 Suction cup pad 
WE
 Dual valve (light green) 
WDG
 Dual valve (dark green) 
WDG
 Pump (light green) 
WCG
 Pump (dark green) 
WCG
 Motor box 
WA
 Geckobot eye stickers 
R#-US
9 cm x 2 15 cm x 2 17 cm x 2 20 cm x 3 27 cm x 2
NOTE! Cutting the tube to length
You must cut the 200-cm tube into these lengths. The specific lengths needed for each
model are indicated in the assembly instructions for each model. You will have 4 cm of
tube left over after cutting. You can use the measuring guide on the left edge of this page.
You can also write the lengths on the tubes with a pen so they are easier to tell apart.
16
1
What’s inside your experiment kit:
You will also need:
 x AAA batteries (.-volt, type
AAA/LR), scissors, ruler or
measuring tape, smooth flat
climbing surface (such as glass,
plastic, or smooth laminate),
small Phillips-head screwdriver,
a few sheets of paper, sheet of
thin plastic (such as a binder
cover), marker
Checklist: Find – Inspect – Check off
2 3 4 5 6 7 8 9 10 11 12 13 14 15
17 18 19 20 21 22 23 24
25 26 2827 29 30 31 32 33 34
35 36 37 38 40 4139
27
20
17
15
9
Centimeters
0
› › › KIT CONTENTS
2
GOOD TO KNOW !
If you are missing any
parts, please contact Thames  Kosmos
customer service.
US: techsupport@thamesandkosmos.com
UK: techsupport@thamesandkosmos.co.uk