Multimedia Bluetooth
®
Speaker System
User Manual 8018049
INTRODUCTION
Thank you for purchasing the inStudio
™
Multimedia Bluetooth
®
Speaker
System. The speaker produces rich sound that will be ideal for your PC,
iPod
®
, iPhone
®
, MP3 player and other portable audio devices enabled with
a 3.5mm jack. Now you can seamlessly stream music from your iPad
®
,
iPhone
®
, Android™ device, laptop, or other Bluetooth
®
-enabled devices.
PACKAGE CONTENTS
• Subwoofer x 1
• Satellite speakers x 2
• User Manual x 1
• Audio cable x 1
WARNINGS
Caution! Read these instructions. Keep these instructions for future
reference. Heed all warnings. Follow all instructions.
• Do not use this apparatus near water–the appliance should not be used
near water or moisture (i.e. In a wet basement or near a swimming pool)
• Clean only with a dry cloth
• Do not install near any hear sources such as radiators, heat registers,
stoves, or other apparatus (including amplifi ers) that produce heat
• Only use attachments/accessories speci ed by the manufacturer
• Unplug the apparatus during lightning storms or when unused for long
periods of time
• Refer all servicing to quali ed personnel
SPECIFICATIONS:
Output Power: 28W + 14W x 2 (RMS)
Speaker Unit: Full-Range Speaker: 2.5”, 4 Ohms
Subwoofer: 6.5”, 8 Ohms
Impedance: 8 Ohms/4 Ohms
Frequency Response: Satellite Amplifi er: 250-20 kHz
Subwoofer Amplifi er: 30-100 Hz
Power Supply: 120V
~
60Hz
Signal Input: RCA jack
S/N Ratio: ≥70dB
Separation: ≥ 40dB
Unit Size: Subwoofer: 235 x 245 x 235 mm (WxDxH)
Satellite: 140 x 138 x 134 mm (WxDxH)
SPEAKER CONNECTIONS
INSTRUCTIONS
1. Connect each satellite speaker to the subwoofer–red RCA plug into the
red audio output, and the white plug into the white audio output.
2. Connect the RCA cables into the input jacks matching red to red and
white to white. Connect the green adapter to your device.
3. Turn on the power and adjust the volume level to your desired
preference. A blue LED light surrounding the volume control glows
when power is turned on.
SPEAKER CONNECTIONS
INSTRUCTIONS FOR WIRED CONTROLS
1. Source Selection:
Press SOURCE button (10) to switch between Bluetooth
®
or AUX input. Blue
LED light for Bluetooth
®
input and red LED for AUX.
2. Bluetooth
®
Pairing:
a) For every new Bluetooth
®
device, you should pair the device with the
unit the rst time. When you press the PAIR button (11), the blue LED
will fl ash quickly. Activate the Bluetooth
®
function on your device and
search for “inStudio 8018049” on the list. After pairing successfully, the
blue light will stay lit.
b) The unit will pair with your device automatically after the fi rst pairing.
3. NFC Pairing:
Note: Please make sure that your smartphone/tablet supports NFC an
Bluetooth
®
over NFC.
a) Activate the NFC functionality in your smartphone or tablet.
b) Place the device on the NFC mark on the top side of the subwoofer and
keep it there until the speaker is paired and connected.
c) Move the smartphone or tablet and start playing your music.
To Next Page
Need help?
General