Theben theLuxa S360 WH User Manual

1
theLuxa S360 WH 1010510
theLuxa S360 BK 1010511
309699
Motion detector
EN
1. Essential safety instructions
Danger of death through electric shock or fire!
 Installation should only be carried out by a pro-
fessional electrician!
WARNING
•
The device conforms with EN 60669-2-1 when correctly
installed
•
IP 55 in accordance with EN 60529
Designated use
•
Motion detector for automatic lighting control dependent
on presence and brightness
•
Suitable for installation on external walls or ceilings
•
Suitable for entrances, garages, gardens, corridors, parks,
etc.
•
Only intended for installation outside of arm‘s reach
Disposal
Dispose of the motion detector in an environmentally sound
manner (electronic waste)
2. Description
3 potentiometers
for setting time
(min) and bright-
ness (lux) and
sensitivity (Meter)
Motion detector
with sensor head
3. Connection
WARNING
Danger of death through electric shock!

Disconnect power source!
 Cover or shield any adjacent live components.
 Ensure device cannot be switched on again!
 Check power supply is disconnected!
 Earth and bypass!
The device can be manually activated with a circuit breaker.
After releasing the button (return of power) the device swit-
ches on (for at least 40 secs or for the time set on the device).
4. Installation
 If applicable, use optional corner bracket (9070902,
9070903) or optional spacer frame (9070906, 9070907) for
exible installation as well as cable insertion from side or
top/bottom.
230V
 Disconnect power source.

Theben theLuxa S360 WH Specifications

General

Detection Angle	360°
Power Supply	230 V AC
Switching Capacity	2000 W
Installation	Ceiling-mounted
Color	White
Mounting Height	2 - 4 m
Power Consumption	0.5 W
Switching Capacity (resistive)	2000 W
Type	Motion Sensor
Time Setting	10 s - 15 min

Summary

Essential Safety Instructions

Designated Use

Describes the motion detector's intended application for automatic lighting control.

Disposal

Instructions for disposing of the motion detector in an environmentally sound manner.

Description

Connection

Installation

Dismantling

Installation Advice

Avoidance of Installation Situations

Advises against installing detector near heat sources or reflective surfaces.

Direction Test and Alignment

Use Screens

Setting

Set Brightness (Lux)

Guides on adjusting the lux sensitivity for the motion detector.

Align Motion Detector

Instructions on how to adjust the sensor head's angle and direction.

Set Time (Min)

Explains how to set the switch-off delay time for the motion detector.

Set Sensitivity (Meter)

Details on adjusting the motion detection sensitivity and range.

Technical Data