Thecus N7700 - Page 4

N7700 motherboard and power supply replacing SOP 4/4 11/11/2008
N7700 motherboard and power supply replacing SOP
2-8. Unscrew the power supply unit and then take it away from the metal frame.
2-9. Reverse above steps 2-1 to 2-6 to assemble the NAS unit with new motherboard or new
backplane board.
3. Warning
3-1. When attach two flat cable connectors to the motherboard in step 2-5, make sure the pin1
(red wire) is farthest to the ATX 20 pin power connector. The motherboard may be burnt
if you shift the pin header or put pin1 nearest the ATX 20 pin power connector.
EOF