1. Open the cover by gently detaching the 2 retention clips.
2. Swing the hinged cover so it ips under the lamp.
3. Select one of the 3 angle slots and
insert the stand tab. Lowest is 20°,
middle is 25° and the top angle of
the lamp is 30° from vertical.
4. Loosen the back knob to adjust
the height and orientation of the
lamp and re-tighten at desired
position. Be careful not to
overtighten and damage the lamp.
5. When the lamp is no longer
needed, it may closed and stored.
Always ensure that the both the
lamp and plug are cool before
storage.
To Next Page
Loading...