• 3 / 12 •
3. Place the plastic grille on TOP of the unmelted
paraffin.
4. Rest the lid on top of the paraffin and grille. The
paraffin will compact as it melts.
5. Plug the unit in.
6. The paraffin will melt in about 6 to 8 hours.
7. Keep the unit plugged in continuously so that
it is always ready for use.
Adding Refill Paraffin
1. Keep the paraffin level to the desired level: 6lb -
standard usage, 8lb - max. deep immersion foot
level, 9lb - max. deep immersion hand level. Do not overfill
the unit.
2. For optimal performance use only Therabath brand refill
paraffin.
Treatment Guidelines
• Refer to contraindications before use.
• Cleanse and dry the skin before applying paraffin.
• Keep clothing and jewelry away from the treatment area.
• Do not remelt used paraffin, discard.
• Keep the lid on when unit is not in use.
1. Apply Pre-treatment Cleansing Spray.
††
(Do not use spray near the eyes, nose, or mouth.)
2. Apply Hydrating Cream.
††
3. Slowly dip hand, foot, elbow, or other treatment area into the paraffin.
4. Remove and wait a few seconds. Repeat 3 to 10 times.
5. Cover hand or foot with a plastic liner.
††
6. Slip on an insulated mitt or boot to retain heat.
††
7. Keep paraffin in place for 10 to 15 minutes.
8. Remove. Discard used paraffin and plastic liner (if used).
††
OPTIONAL: Pre-treatment Cleansing Spray, Hydrating Cream, plastic liners, mitts,
boots, and more are sold separately. Call your dealer or WR Medical Electronics:
www.therabath.com.
Cleaning Instructions
• Clean the unit after every 40 treatments, when the paraffin is no longer clear, or whenever
sediment accumulates on the bottom.
• Do not scratch or damage the inside tank coating.
• Do not immerse the unit in water.
• Do not use abrasive scouring powders of any kind when cleaning the tank.
1. Unplug the unit. Remove the grille. Allow the paraffin to solidify.
2. After the paraffin is solid, plug the unit in until the paraffin loosens from the tank. Unplug
the unit.
3. Push down firmly on one end of the paraffin to tilt the opposite end up. Lift out the cake
and dispose. Do not use sharp objects.
4. Remove remaining paraffin in the tank with soft paper towels.
5. Clean the inside and outside with an all-purpose cleaner. Wipe dry.
6. Refill with Therabath
®
brand paraffin.
Maintenance and Service
US and Canadian Customers
• Device is not user serviceable.
• Contact the manufacturer to obtain service assistance, return authorization instructions and
prior approval before shipping the product prepaid for warranty service. Proof of purchase,
name, address, contact information and a detailed description of the defect are required.
The purchaser is responsible for shipping and handling expense for all warranty service.
To Next Page
Loading...