Safety
1. Do not blow air directly into air purifier.
2. Keep both sides of the unit at least 1 foot away from a wall.
3 Do not place the unit near curtains.
4. Placing the unit close to the source of air pollution is an effective way to improve
indoor air quality.
With very little effort, the Therapure
®
201 air purifier delivers cleaner, fresher, sanitized air to your
indoor environments.
Keep your Therapure
®
201 functioning properly by cleaning the Permanent HEPA type Filter. More
frequent cleaning will be necessary if the unit is located in an area with a high level of airborne
contaminants (excessive amounts of smoke, pet dander, etc.).
Exposing your Therapure
®
to candle/oil/fireplace soot and smoke is not recommended and will
require more frequent cleaning.
Remember: Always make sure your air purifier is turned off and unplugged before cleaning.
Cleaning the Permanent HEPA type Filter
a. Clean the Permanent HEPA type Filter after each month of use.
b. Be sure to turn off and unplug the unit before cleaning.
1. Release the inlet grill by pressing on the Locking Latch (see diagram of Main Parts).
2. Remove the inlet grill from the unit as shown below.
3. Grasp the left and right frames of the Permanent HEPA type Filter through the indentations on
the sides of the filter enclosure and remove the filter.
4. To clean the Permanent HEPA type Filter, use the brush attachment with your vacuum cleaner.
Run the attachment along the inlet and outlet side of the filter, cleaning between the crevices as
much as possible. Do not use water or any household cleaners or detergents to clean the
Permanent HEPA type Filter.
1. 2.
4.3.
1. 2.
3. 4.
To Next Page
Loading...
