ThermaCor Thermax Therminator DV12

Questions and Answers

H
heatherguzmanAug 5, 2025
How to troubleshoot ThermaCor Cleaning Equipment that will not operate?
- L
  Lauren SnyderAug 5, 2025
  If your ThermaCor Cleaning Equipment isn't operating, consider these potential causes and solutions: * Ensure the equipment is plugged into a live, grounded outlet. * Check for and replace any blown fuses or breakers. * Inspect the power cord for defects and replace if necessary. * Examine the switch and replace it if defective. * Verify that all wiring is properly connected. * Confirm the connection is firmly pressed into the outlet.
H
Hannah RussoAug 10, 2025
What to do if the pump runs but ThermaCor Thermax Therminator DV12 won't spray or has weak spray?
- T
  Trevor NashAug 10, 2025
  If the pump of your ThermaCor Cleaning Equipment is running but there's no spray or a weak spray, check these: * Refill the solution tank if it's empty. * Remove any blockage from the spray jet. * Clear any obstructions in the hose coupling. * Clean the solution filter if it's obstructed. * Replace any damaged hose. * Consider replacing the pump if components are wearing out.
S
Stephanie WilsonAug 15, 2025
Why is there a loss of vacuum suction in my ThermaCor Thermax Therminator DV12 Cleaning Equipment?
- M
  mullinsjamesAug 15, 2025
  A loss of vacuum suction in your ThermaCor Cleaning Equipment could be due to several reasons: * Ensure the recovery dome is properly seated for a better seal. * Check for and remove any obstructions in the vacuum hose or wand. * Remove debris from the screen filter if it's clogged. * Replace the dome gasket if the recovery dome needs one.
D
Deanna HolmesAug 20, 2025
How to fix a ThermaCor Thermax Therminator DV12 vacuum motor that will not run?
- B
  bennettdominicAug 20, 2025
  If the vacuum motor on your ThermaCor Cleaning Equipment isn't running, check these items: * Make sure the preheat switch is in the “OFF” position. * Tighten and connect any loose wiring. * Replace the vacuum switch if it's defective. * Replace the vacuum motor if it's defective.
D
Dr. Ann OwensAug 25, 2025
Why won't the water heat in my ThermaCor Thermax Therminator DV12?
- B
  Bradley LongAug 26, 2025
  If the water in your ThermaCor Cleaning Equipment isn't heating, consider these possible causes: * Reset the thermo reset switch if it has tripped. * Replace the heater element if it's damaged. * Replace the thermo disk if it's defective. * Replace the preheat switch if it's defective. * Ensure the Preheat is switched to the “ON” position to activate the heater.
E
Emily SparksAug 30, 2025
What does it mean if there is no indicator light on ThermaCor Thermax Therminator DV12 Cleaning Equipment?
- M
  Mrs. Melissa WardAug 30, 2025
  If there's no indicator light on your ThermaCor Cleaning Equipment, it could mean one of two things: * The indicator lamp may be faulty and need replacement. * The solution may be up to temperature, requiring no action.