Do you have a question about the Thermador C272 and is the answer not in the manual?
Troubleshooting steps for P2, the lower oven sensor.
Troubleshooting steps for P3, the upper oven sensor.
Troubleshooting steps for P5, the lower oven door latch.
Troubleshooting steps for P9, the upper oven door latch.
Troubleshooting for P10, display signals to the head.
Troubleshooting for P11, communication signals to the head.
Troubleshooting for PO, door latch motors.
Troubleshooting for P18, the relay board transformer.
Troubleshooting for P1, cooling motors and halogen lights.
Troubleshooting for P8, the lower oven convection motor.
Troubleshooting for P7, the upper oven convection motor.
Troubleshooting for P14, the upper oven double line break relay coil.
Troubleshooting for P15, the lower oven double line break relay coil.
Troubleshooting for P10, display signals to the head.
Troubleshooting for P11, communication signals to the head.
Troubleshooting for P2, the upper oven meat probe.
Troubleshooting for P6, the upper oven air switch.
Troubleshooting for P4, the lower oven air switch.
Troubleshooting for P8, power supply to the control board.
Troubleshooting for P1, display/communication signals to TCB.
Troubleshooting for P2, commands to display head.
General procedures for testing oven components.
Procedure for testing the blower motor.
Procedure for testing the air switch.
Procedure for testing the convection fan motor.
Procedure for testing the lamp transformer.
Procedures for testing the oven door latch assembly.
Steps to test individual latch switches.
Steps to test the door latch motor windings.