EasyManua.ls Logo

Thermal Solutions AMP 1000 - Page 48

Thermal Solutions AMP 1000
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
48
X(continued)

System Circulator
Hydraulic Separator
Isolation Valve
Check Valve
Boiler Circulator
Expansion Tank
Pressure Reducing Valve
Check Valve
Make Up Water
From System
To System
Thermal Solutions Products LLC
Notes:
1. This is a suggested piping configuration. It is the
installer's responsibility to to conform to local codes
and ordinances for additional requirements.
2. Pressure relief valve shall not exceed the pressure
rating of any components in the system.
3. The boiler pump shall be sized to overcome the
pressure drop across the entire boiler loop.
11/12/2018
Multiple AMP Boiler Piping with Hydraulic Separator
NOTICENOTICE
 

 

       

 

!
Purge Vavle
From System
Air Vent
Pressure Reducing Valve
Check Valve
DWH Circulator
System Circulator
To System
Back Flow Preventer
Tempering Valve
Isolation Valve
Factory Supplied Manifold
Isolation Vavle
Boiler Circulator
Check Valve
Y-Strainer
Expansion Tank
Indirect Domestic Water Heater
Make Up Water
Hot Water
Cold Water
Thermal Solutions Products LLC
Notes:
1. This is a suggested piping configuration. It is the
installer's responsibility to to conform to local codes
and ordinances for additional requirements.
2. Pressure relief valve shall not exceed the pressure
rating of any components in the system.
3. The boiler pump shall be sized to overcome the
pressure drop across the entire boiler loop.
8/30/2019
AMP boiler piping with H2O Max


Table of Contents

Related product manuals