EasyManua.ls Logo

Thermal Solutions AMP 1000 - Page 54

Thermal Solutions AMP 1000
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
54
NOTICENOTICE
 

 

       

 

!
System Circulator
Hot Water Return
Factory Supplied Manifold
Check Valve
Water Heater Circulator
Y-Strainer
Isolation Valve
Storage Tank
Thermometer
Mixing Valve
Cold Water Supply
Hot Water Supply
Exansion Tank
T&P Relief Valve
Recirculation Filter
Thermal Solutions Products LLC
Notes:
1. This is a suggested piping configuration. It is the
installer's responsibility to to conform to local codes
and ordinances for additional requirements.
2. Pressure relief valves shall not exceed the pressure
rating of any components in the system.
3. The circulator shall be sized to overcome the
pressure drop across the entire loop.
5/28/2019
AMP Water Heater Piping with Tank

XI(continued)

Table of Contents

Related product manuals