EasyManua.ls Logo

Thermaltake Dr.Power III - User Manual

Thermaltake Dr.Power III
2 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Dr.Power III
User Manual
24pin connector
Check button
CPU 4pin or 8pin connector
Peripheral connector
SATA connector
PCI-E 6pin or 8pin connector
12+4pin connector
Connector Introduction
Operation Instructions
Manual Mode
1. Plug the PSU connectors into Dr.Power III.
2.Switch the PSU I/O switch to the “-” position. The screen will then display the TT logo animation.
3.The screen will display the icons of the connectors that have been plugged into Dr.Power III.
4.Press the CHECK button to start the manual testing mode. The screen will display the 24P icon, the output voltage of
each group, and PG.
5.Press the CHECK button again. The system will proceed with the next test point CPU. The screen will display the CPU icon
and the corresponding voltage output.
6.Press the CHECK button again. The system will proceed with the next test point PCI-E. The screen will display the PCI-E icon
and the corresponding voltage output. If the PCI-E 12+4pin is connected, the screen will display the SENSE0/SENSE1
sideband signals of the PCI-E 12+4pin connector (150W/300W/450W/600W).
7.Press the CHECK button again. The system will proceed with the next test point MOX. The screen will display the MOX icon
and the corresponding voltage output.
8.Press the CHECK button again. The system will proceed with the next test point SATA. The screen will display the SATA icon
and the corresponding voltage output.
9.Press the CHECK button again to return to step 3.
10.If no fault occurs during the test, the LCD backlight will remain white. Once any fault occurs, the LCD backlight will turn red
and make a “beep” sound.
Connect all of the
connectors and
turn on the PSU
Press button Press button
Press button
Press button
Press button
Press button
Note: 12+4P will only be displayed when
PCI-E 12+4pin is connected.
SATA
SATA
297 mm
210 mm
稿
Dr.Power III
AC-069-OO1NAN-A1
Manual(英文)
231221
A1
105
X
2
(g/m )
CHECK DESIGN
Pok
231221
X X
Joyce
231221
X
商: 僑
Question and Answer IconNeed help?

Do you have a question about the Thermaltake Dr.Power III and is the answer not in the manual?

Summary

Connector Introduction

Operation Instructions

Manual Mode Testing

Step-by-step guide for manual testing of PSU connectors, detailing each test point.

Auto Mode Testing

Specifications and Support

Thermaltake Dr.Power III Specifications

General IconGeneral
ModelDr. Power III
CategoryTest Equipment
TypePower Supply Tester
Voltage TestingYes
DisplayLCD
CompatibilityATX, BTX, ITX
ConnectorsSATA, Molex
Voltage Range3.3V, 5V, 12V
ProtectionShort circuit protection