Thermaltake Pacific PR22-D5 Plus

To Next Page

This product is intended for installation only by expert users. Please consult with a qualified technician for installation.

Improper installation may result in damage to your equipment.

1. Please carefully read the manual before beginning the installation process !

2. It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000.

3. DO NOT USE any kind of alcohol or alcohol derivatives with this reservoir or the acrylic tube may crack and fail ! Do not clean it using alcohol either !

Installation Guide

Parts List

Clip

Nuts

Wrench Clip Sponge Bracket

Bracket Sponge

G1/4 Stop Plug

Wrench

Cable Ties

Short Screws

Long Screws

A x 2

B x 8

C x 8

D x 1

E x 2

F x 2

G x 4

H x 2

L x 1 M x 1 N x 1 O x 1 P x 1 Q x 1

I x 1

J x 1

K x 4

There are two types of mounting kits,

please choose the mounting kit you want to

use (Both types can be installed together)

Install your fittings and tubes,

remember to use the bottom as

an outlet and top as an inlet.

Connect the reservoir cable to

the conversion cable.

1 2

More Language (Deutsch, Español, Français, Italiano, Português,

Русский, Türkçe, 简体中文, 正體中文, 日本語, ภาษาไทย)

Please visit www.thermaltake.com

Support

16.8 Million Colors

Pacific

PR22-D5 Plus

Pump+Reservoir

Controller Power Cable

Velcro

Controller Cable Conversion cable

Bridge Cable

1 0 5 G是 X X

雙銅

單色無無

其他特殊處理效果表面處理

厚度(g/m )

折數材質雙面印刷印刷色彩單面印刷

規格樣式

單張

CHECK DESIGN

藍色線條為尺寸標示，請勿印刷上去！

210 mm

297 mm

刀模線

產品料號

C L - W 18 7 -P L0 0 SW - A P a c i fi c P R2 2- D 5 Pl u s 說明書 17/07/0 3 A

產品名稱

印刷項目

發稿日期

版本

Peipei

(17/07/03)

Mike.Lin

(17/07/03)

Need help?

Do you have a question about the Thermaltake Pacific PR22-D5 Plus and is the answer not in the manual?

Summary

Parts List

Reservoir Controller

Includes the pump controller and associated cables for system integration.

Mounting Hardware

Various screws, nuts, clips, and brackets for securing the reservoir.

Ancillary Components

Includes items like cable ties, velcro, and wrenches for installation and management.

Installation Guide

Step 1: Initial Assembly

Assemble the base, reservoir tube, and mounting brackets.

Step 2: Fitting and Tube Installation

Install fittings and tubes, connecting to the bottom outlet and top inlet.

Step 3: Cable Connection

Connect the reservoir cable to the conversion cable.

Step 4: Controller Setup

Connect the reservoir cable to the controller unit.

Step 5: Controller Configuration

Set the DIP switch on the controller to assign its number.

Step 6: Mainboard Connection

Connect the controller cable to the mainboard's USB 2.0 header.

Step 7: Power Connection

Connect the power cable to the controller via a 4-pin Molex connector.

Step 8: Multi-Controller Linking

Use bridge cables to connect multiple controllers together.

Step 9: Coolant Filling and Caution

Fill reservoir to 80%, leave fill port cap off, and avoid coolant on LED module.