Need help?Do you have a question about the THERMEx TFMH 360 and is the answer not in the manual?
General| Type | Built-in |
|---|---|
| Control type | Buttons |
| Product color | Stainless steel |
| Motor included | Yes |
| Built-in display | No |
| Exhaust connection diameter | 150 mm |
| Noise level | 61 dB |
| Pressure (Pa) | 98 |
| Number of speeds | 4 |
| Type of extraction | Ducted |
| Noise level (low speed) | 40 dB |
| Maximum extraction power | 312 m³/h |
| Lighting efficiency class | A |
| Fluid dynamic efficiency class | G |
| Grease filtering efficiency class | C |
| Connected load | 24.1 W |
| AC input voltage | 230 V |
| Energy efficiency scale | A to G |
| Annual energy consumption | 73 kWh |
| Bulb type | LED |
| Illuminance | 235 lx |
| Number of bulbs | 2 bulb(s) |
| Lighting position | Front/Back |
| Grease filter type | - |
Weight and Dimensions| Depth | 277 mm |
|---|---|
| Width | 547 mm |
| Height (max) | 262 mm |
The range hood shall be extra protected cf. the high voltage regulations.
Connect the tube to the outlet flange with collar clip, checking the counter damper.
Make the electrical connection, noting leads for TFH and TFMH models.
Decide where to place the control panel: immediately under hood or on cabinet outside.
Connect the control panel lead through holes to the control panel and attach it.
Lead out from hood, place panel, connect lead, attach panel to a cleaned flat area.
Fit the range hood in the opening and attach with 4 of the 8 enclosed screws.
Never connect the outlet range hood for existing hot air system or chimney.
Fit carbon filter using two metal bars in the grease separator. Dismantle to remove bars.
Button to control the light of the range hood.
Button to turn off the motor of the range hood.
Button to turn on and select motor speed from 1 to 3.
Used for strong food odour/smell. Runs for 5 mins then returns to previous speed or turns off.
Light diode for metal filter cleaning. Reset by holding OFF button for motor.
Runs hood for 15 mins then stops. Press again to interrupt and run until OFF.
Activate timer function, select speed/time, confirm with OFF button.
Diode indicators show 5, 10, or 15 minutes of operation per hour.
Disconnect power for 5 sec, then reconnect and try again if not working.
To Next Page