M 900212100213112023 THERMEX THERMEX TX-SERIES 67
ENGLISH
»
CLEANING AND MAINTENANCE
CLEANING AND MAINTENANCE
DAILY CLEANING
• Surfaces and glass plate are cleaned with a damp cloth with washing-up liquid.
• Lacquered surfaces are cleaned with a damp cloth with sulfo/detergent. NEVER use abrasives.
What? How Important!
Everyday dirt on
glass (finger-
prints, marks,
food stains or
non-sugary
spill-overs on the
glass)
1. Turn o the power to the hob.
2. Apply a hot plate while the glass is still
warm (but not hot!)
3. Rinse and dry with a clean cloth or paper
towel.
4. Switch on the power to the stove again.
·When the power to the hob is switched
o, there will be no ’hot surface’ indica-
tion, but the cooking zone may still be
hot!
· Powerful scrubbers, some nylon scrub-
bers and harsh/abrasive cleaners can
scratch the glass. Always read the label
to check if your cleaning or scrubbing
machine is suitable.
· Never leave cleaning residue on the
hob: the glass may become stained.
Overboil, melted
and hot sugary
spill on the glass
Remove these immediately with a fish
slicer, palette knife or razor blade scra-
per suitable for induction glass hobs, but
beware of hot cooking zone surfaces:
1. Turn o the power to the hob at the wall.
2. Hold the blade or utensil at a 30° angle
and scrape the dirt or spill onto a cool area
of the hob.
3. Clean the dirt or spill with a dish cloth or
paper towel.
4. Follow steps 2 to 4 for ’Everyday dirt on
glass’ above.
·Remove stains left by melts and sugary
foods or spills as soon as possible. If left
to cool on the glass, they can be dicult
to remove or even permanently damage
the glass surface.
·Cutting hazard: When the safety cover
is retracted, the blade of a scraper is
razor sharp. Use with extreme caution
and always keep safe and out of the
reach of children.
Spill on the touch
control
1. Turn o the power to the hob.
2. Absorb the spill.
3. Wipe the touch control area with a clean
damp sponge or cloth.
4. Dry the area completely with a paper
towel.
5. Switch on the power to the hob again.
The hob may beep on and o by itself
and the touch buttons may not work
while there is liquid on them. Be sure to
wipe the touch control area dry before
switching the hob back on.
To Next Page
Loading...
