Need help?Do you have a question about the Thermia EM3 and is the answer not in the manual?
General| Protection Class | IP20 |
|---|---|
| Power Consumption | 5 W |
| Operating Temperature | 50 °C |
| Storage Temperature | -20°C to +70°C |
| Relative Humidity | Max. 95%, non-condensing |
| Communication | Modbus RTU |
| Display | LCD |
Essential safety measures and warnings for handling the heat pump and its components.
Information regarding the intended audience and adherence to standards for this manual.
Details on the electrical load limits for various components and outputs of the EM3 module.
Lists and illustrates the components included in the EM3 kit and required external parts.
Guidelines on where and how the EM3 module can be installed, indoors or outdoors.
Instructions for mounting and connecting the EM3 module inside the heat pump's electrical cabinet.
Details on how to mount the enclosure for external installation using screws or brackets.
Steps for wiring, fitting the EM3 unit onto the mounting plate, and securing it.
Description of Tap Water Control (TWC) and Water Charge System (WCS) functions.
Configuration and use of EM3 for controlling heating/cooling distribution circuits 2 and 3.
Configuration and use of EM3 for controlling heating/cooling distribution circuits 4 and 5.
Details on passive/active cooling modes, cooling towards borehole, and cooling towards chiller.
Setup and operation of pool heating and circulation control using EM3.
Control of external heat pumps not using the Genesis control system.
Activating internal brine pumps based on external signals for cooling or other systems.
Starting external brine pumps using a 0-10V signal for temperature control.
Final inspection of wiring, placement of decals, and securing the enclosure cover.
Reference list of numbers and their corresponding components used in the wiring diagrams.
To Next Page