Section 9 Parts Replacement
Part replacement procedures follow.
1. Disconnect power.
2. Remove screws in front which secure lower oven floor and lift out.
3. Disconnect heater terminals and heater mounting screws.
4. Replace with new heater, reinstall in reverse order.
1. Disconnect power.
2. Open door as wide as possible.
3. Open control panel by removing two top screws. Set panel down,
exposing controls.
4. Unplug the heater connection located on the board.
5. Remove 2 screws from stainless steel flange just above control panel.
6. The chamber floor is now free. Pull forward and lift out.
7. Disconnect heater leads.
8. Remove heater leads and connector from the opening in control panel.
9. Replace heater leads by reversing these steps.
3177885 Thelco Oven 9-1Thermo Electron Corporation
Heater Replacement
Heater Wire
Replacement
To Next Page
Loading...