Need help?Do you have a question about the thermo spectronic GENESYS 10 and is the answer not in the manual?
General| Type | UV-Visible Spectrophotometer |
|---|---|
| Wavelength Range | 190 - 1100 nm |
| Detector Type | Silicon photodiode |
| Display | LCD |
| Baseline Flatness | ±0.002 A |
| Interface | RS-232 |
| Power Requirements | 100-240V AC, 50/60 Hz |
| Photometric Range | -0.3 to 3.0 A |
| Light Source | Tungsten-Halogen and Deuterium lamps |
| Sample Holder | Standard 10 mm cuvettes |
| Data Output | RS-232 |
| Stray Light | <0.05% T at 220 nm |
Steps for unpacking, placing, and connecting the instrument.
Performing cell correction for accurate measurements.
Using Auto 6 or Auto 3 modes for sample measurement.
Performing absorbance and transmittance measurements.
Measuring the reference sample.
Measuring sample absorbance or transmittance.
Measuring concentration using factors or standards.
Measuring the reference sample for concentration tests.
Measuring a standard sample for concentration calibration.
Inputting a factor for concentration calculations.
Measuring unknown samples for concentration.
Detailed absorbance/transmittance measurements.
Acquiring data for Advanced A/%T/C tests.
Concentration measurements using Advanced A/%T/C.
Inputting a factor for Advanced A/%T/C concentration.
Measuring unknown samples for Advanced A/%T/C concentration.
Measuring standard samples for curve creation.
Automatic standard measurement for curve.
Manual standard measurement for curve.
Measuring unknown samples using a standard curve.
Measuring unknown samples for Absorbance Ratio.
Automatic unknown measurement for Absorbance Ratio.
Manual unknown measurement for Absorbance Ratio.
Measuring unknown samples in Kinetics mode.
Recording a baseline scan.
Performing a scan on an unknown sample.
Performing multi-wavelength measurements.
Manual multi-wavelength measurements.
Proper methods for cleaning cuvettes and flowcells.
To Next Page