THERMOBIND TB500 User Manual

1. Plug directly into an 120Volt outlet. Turn on the power switch
located at the right front. The machine beeps when ready. (about 3
minutes)
2. Press the “SELECT” button to select your choice of I, 60 seconds, II,
120 seconds, or III, ( both the I and the ll lit up) 180 seconds.
3. Fill your thermal binding cover(s) with the sheets you wish to bind.
Place the cover(s) into the machine with the spine resting squarely
on the heating plate.
4. An electric eye will cause the cycle to begin when the covers are
inserted into the machine.
5. The machine will beep when the cycle is done.
6. Before removing the booklet(s) from the machine, push down on
the pages while holding the front and back covers firmly so that you
can be sure that all the pages are making contact with the melted
adhesive.
7 . Remove the bound book(s) from the machine. Place it in the
cooling rack and leave it for about 5-10 minutes. Do not try to open
the book(s) until it has thoroughly cooled.
8. To continue binding, please repeat steps 3 through 7.
9. Turn the machine off after binding.
Automatic Shutoff
Customer Support
We’re committed to helping our customers get the best
binding results. Please call us toll free at 888-992-4144 if you
are not getting the results you expect and we will troubleshoot
the problem with you live. Our hours are 9:00 AM to 5:00PM
Eastern time, Monday through Friday. You can also email
sales@thermobind.com for a prompt reply.
If a cover is left in the machine after binding the machine will
cut power to the heating plate after 5 minutes. If the machine
is empty but is not used for fifteen minutes it will
automatically shut off. To restore power, turn the machine off
and then on again.
USERGUIDE FOR THERMOBIND TB500
Operating Instructions:
5/13/20

THERMOBIND TB500 Specifications

General

Dimensions	20.5 x 9.25 x 4.5 inches
Weight	6.2 lbs
Binding Type	Thermal
Max. Binding Thickness	50 mm
Heating Temperature	150°C

Summary

Automatic Shutoff

Customer Support

Operating Instructions

Setup and Cycle Selection

Plug in, turn on the machine, and select binding cycle time (60, 120, or 180 seconds).

Binding Process

Fill covers, insert into machine, ensure page contact, remove, and cool for 5-10 minutes.

Repeat Binding and Power Off

Repeat binding steps as needed, then turn off the machine when finished.

Safety Instructions

Basic Machine Maintenance

Trouble Shooting Guide

No Power or LED Indicator

Check power connection, ensure switch is on, reset shutoff, or call for repair.

Improper Binding and Loose Pages

Achieving Good Binding

Use enough heat/time for adhesive to wick into paper for a strong bind.

Spine Size and Page Count

Match spine size to paper stack width; underfilling is better than overfilling.

Binding Thick Documents

For thicker items, repeat the cycle or extend time slightly for better adhesion.

Coated Papers and Waviness

Use sandpaper on paper edges for better adhesion on coated papers or to prevent waviness.