27 Rosalie Street, Springvale VIC 3171
P: +61 (0)3 9562 3455 F: +61 (0)3 9548 3979
sales@thermofilm.com.au
www.thermofilm.com.au
2. Specification Data
Model Supply Max. Load Power
TT-MTC2-4A 230-240 volt AC 13 Amps (resistive) 3100 Watts
3. Operations Instructions
To set 2 hour/4 hour/6 hour mode
• Press the On/Off button once and the 2 hour LED light will come on.
• Press the On/Off button again and the 4 hour LED light will come on.
• Press the On/Off button again and the 6 hour LED light will come on.
• Press the On/Off button again and the unit will turn off.
NB: The Power LED will be lit up when the heating is on.
Temperature Control Settings
Comfort: 18°C – 26°C
Backup: 5°C – 15°C
NB: The above temperature parameters will be set by the Installer..
4. Installation
Installation Guidelines:
• All electrical connections are to be performed by a registered electrician only, as required by
law.
• Ensure that the supply is disconnected at the distribution board.
• All connections are secure and tested prior to activation.
• You have studied and fully understood the connection diagram.
• Thermostat must be installed in the same room as the heating system.
• The thermostat must be installed on an inside wall
• Avoid location where there are air drafts (top of staircase, air outlets), dead air spots (behind
doors), direct sunlight or concealed chimneys.
• Must be installed using a plastic (not metal) wall box (i.e. Clipsal 157/1P).
To Next Page
Loading...