Part No. MI110 Rev.13.0 November 2023 Printed in Canada
CX & DX Series
Special Notes
ELECTRIC SHOCK HAZARD. All electric heating equipment installations must be
standards and must be effectively grounded to eliminate shock hazard.
FIRE/EXPLOSION HAZARD.
Liquid Immersion Applications
a. Liquid level control to maintain all the heating elements totally immersed at all times,
b.
sheath design temperature
Gaseous and/or vapour phase immersion applications
a. Heating elements sheath temperature controls to limit to the maximum
This heater is not intended to be used in hazardous locations and does not bare
locations.
WARNING
FIRE/EXPLOSION HAZARD.
BI6.5. In case of code stamped of registered heater, do not exceed the rating as stated in
the data report and/or registration documents. Do not operate the heater in the
marked for the hazardous location and heater operating temperature does not exceed
WARNING
FIRE HAZARD. If a thermostat is provided, it is designed for temperature control
temperature limiting duty. Wiring to this device is the users' responsibility.
Heaters are capable of developing high temperatures, therefore extreme care
a.
b.
CAUTION. This document presents the minimum requirement pertaining to the
installation, operation, and maintenance of the respective equipment as required by the
manufacturer only. Any additional considerations, including but not limited to any design
boundary components to meet any safety principles and local jurisdictional regulatory
requirements, shall be the responsibility of the user.
CAUTION
Immersion Heaters
Installation, Operation, & Maintenance Instructions
CAUTION
WARNING
To Next Page
General