Need help?Do you have a question about the Thermon TraceNet TCM18 and is the answer not in the manual?
Describes the wiring and connection details for the TCM18 interface module.
Details wiring and connections for the RTB6 module, used for RTD inputs.
Outlines wiring and connections for the PM6 solid state switching module.
Explains wiring and connections for the RM6 relay interface module.
Guidelines for installing heat trace circuits and insulation per project details.
Proper placement and wiring of RTD sensors for accurate temperature sensing.
Instructions for field power wiring, breaker selection, and voltage/current considerations.
Steps for preparing and energizing the heat trace system for initial operation.
Essential safety guidelines for performing maintenance on the system.
General| Input Voltage | 100-277 VAC |
|---|---|
| Communication Protocol | Modbus RTU |
| Housing Material | Polycarbonate |
| Protection Rating | IP66 |
| Product Type | Control Module |
| Approvals | ATEX, IECEx |
| Output | Relay |
| Operating Temperature | -40°C to 60°C |
To Next Page
