ThermoPro NP17-12 Pro - Default Chapter; Table of Contents

2
TABLE OF CONTENT
1. Introduction ............................................................................................................................................. 3
1.1. Documents take into account at production and in documentation ..................................................... 3
1.2. Briefly about the Manufacturer .............................................................................................................. 3
2. Safety measures working with System ...................................................................................................... 4
2.1. Precautions and safety when using the equipment. .............................................................................. 4
3. The device description ............................................................................................................................... 5
3.1. Technical characteristics of NP Series pre-heating systems ................................................................... 5
3.2. Digital Bottom Pre-Heating and Soldering System of NP Series delivery specification and its
application ..................................................................................................................................................... 6
Technical Characteristics of TP Series Temperature Controllers .................................................. 8
4.1. Before working start ............................................................................................................................... 9
4.2. First Switch On ........................................................................................................................................ 9
4.2.1. Power supply connection .................................................................................................................... 9
5. Equipment operation ............................................................................................................................... 10
5.1 Equipment and Operation ..................................................................................................................... 10
5.2 System’s work in autonomous mode .................................................................................................... 13
5.2.1. Selection of heating channel ob Controller TP2 -10AB ....................................................... 14
5.2.2. Measure of the temperature of stabilization ....................................................................... 14
5.2.3. Heater turn ON and OFF ............................................................................................................ 15
5.2.4. Work with memory ..................................................................................................................... 15
5.2.5. Change of temperature setting limits .................................................................................... 15
5.3. The Sytem work under PC control ....................................................................................................... 15
5.3.1. ThermoGraph read out (for Controllers TP Х-ХKD Pro) ..................................................................... 16
5.3.2. Thermo-profile work out (for Controllers TPХ-ХKD Pro) ................................................................... 16
5.3.3. The procedure of system setting for soldering by thermo-profile .................................................... 16
6. Maintanece .............................................................................................................................................. 18
7. Storage and transportation requirements............................................................................................... 20
8. Terms of Warranty limitation .................................................................................................................. 20
9. Disposal ........................................................................................... Ошибка! Закладка не определена.