Why does my FireAngel® Smoke Alarm activate when no smoke is visible?
If your FireAngel® smoke alarm activates when no smoke is visible, check its location to ensure it's suitable. You may also need to clean the smoke alarm.
What to do if my FireAngel® Smoke Alarm chirps intermittently?
If your FireAngel® Smoke Alarm chirps intermittently, first check its location. Then, make sure that the chirping is actually coming from your smoke alarm. Try to eliminate other alarms as the source of the noise.
What to do if I experience frequent unwanted alarms from my FireAngel® smoke alarm?
If you are experiencing frequent unwanted alarms from your FireAngel® smoke alarm, you should first check the location of the alarm. Also, consider cleaning the smoke alarm.
What to do if FireAngel® smoke alarm does not sound during testing?
If your FireAngel® smoke alarm doesn't sound during testing, especially after activating it or replacing the batteries, wait a few seconds and try again. Ensure you firmly push the center of the test button. If the unit has been silenced and is in low sensitivity mode, wait 15 minutes before retesting.
What to do if the low battery warning silence chirp doesn't silence when I press the test button on my FireAngel® smoke alarm?
If the low battery warning silence chirp doesn't silence when you press the test button on your FireAngel® smoke alarm, it may be because the chirp has been silenced a maximum of 10 times, in which case you should replace the batteries. Also, if the red LED flashes at a separate time from the chirp, a fault is indicated.
Recommends placement for family living units in existing buildings.
Use in flats/bedsits with primary system in common areas.
Use in motels, hospitals, day care facilities, etc.
Explains how to insert batteries and what to expect.
Details attaching the base plate to ceiling or wall.
Describes attaching the alarm to the base plate.
Instructions on how to test the alarm after installation.
Describes the normal LED flashing pattern.
Explains the audible chirp for low battery and replacement advice.
Details silencing the low battery chirp temporarily.
Recommends weekly testing.
Advises cleaning every 3 months with a vacuum cleaner.
General| Type | Optical Smoke Alarm |
|---|---|
| Sensor Type | Optical |
| Battery Life | Up to 10 years |
| Test Button | Yes |
| Alarm Sound Level | 85 dB |
| Weight | 200 g |
| Operating Temperature | 0°C to 40°C |
| Standards Compliance | EN 14604 |
| Dimensions | 130mm x 130mm x 40mm |
| Power Source | 3V Lithium Battery (sealed for life) |
To Next Page
