6
be aligned with the markings on the housing of the heater or the control unit. The radiator is
ready to operate - (circuit controls the heater is shown in Figures 5 and 6).
1 – the thermostat knob
2 – switch power control
(off switch for heater models without power
controller)
3 – off switch
Draught 5: Operating controls location Draught 6: Operating controls location
(IP 20) (IP 24)
1 - the thermostat knob
2 - key power control
(Off key for heater models without power controller)
3 - key off
6. MODE
Warning! It is forbidden to turn on and operate the radiator without attaching it to the wall or
foundation on the floor. Start and run the heater can be only when the air intake grille is facing
down.
6.1 - Connecting the radiator
Plug the power cord into an AC outlet heater. The thermostat is set at the position close to the
"MAX". Turn on the heater by moving the key switch to «I» (key progressive regulator -
positions "I" and "II").
When the room temperature reaches the desired value (you can check the temperature with a
thermometer), slowly turn the thermostat to reduce the numerical values (looking at the
selection), located on the knob, until the function heating is switched off, accompanied by the
characteristic "click" . The selected temperature will automatically continue to persist in the
room.
In order to reduce the room temperature, set the thermostat to meet lower numerical
designation, in order to increase - higher.
To switch the heater mode saves half the power (for radiators with step power) simply set the
control key to "0".
6.2 - Start function antifreeze.
The thermostat knob to position «" and turn on the heater.
6.3 - Disconnect the heater from the mains.
Key regulator should be set (the key of regulated power) to "0", and then unplug the power
cord from the outlet.
6.4 - Removing radiator
Before removing the heater must be disconnected from the network, according to information
To Next Page
Loading...