EasyManua.ls Logo

Thermoval TX - IP24 Installation in Wet Areas; Initial Operation and Thermostat Setting

Thermoval TX
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
draught.1 draught.2
draught. 3 draught. 4
5.5 - Heating type IP24 can be installed in bathrooms, swimming pools (see Fig. 4).
In this case, the installation of the heater of this type is not allowed: a zone (1) bathrooms,
swimming pool, etc .; in the zone (2), where a person located in the bath, shower or swimming
pool can reach a heater or its cord.
Power outlets for heaters should be installed at least 25 cm above the floor and out of the zone
(2).
5.6 - Press the button on the position of incorporation, and then move the knob gradual power
control from the off position "0". The thermostat knob sets the position "" sign "» knob should