What to do if Thetford Water Pump operates but no liquid is expelled?
First, check if the holding tanks are empty. Also, ensure that the RV gate valves are open. If these aren't the issue, your Thetford Water Pump may be clogged.
What to do if Thetford Water Pump motor will not run?
First, ensure the Thetford Water Pump is turned on and that your RV battery is adequately charged. Check the circuit breaker or fuse to confirm it's functioning correctly and that the pump is receiving voltage. Finally, inspect the impeller for any foreign objects that may be preventing its operation.
Why does Thetford Water Pump waste discharge pressure stop or decrease dramatically?
First, check if the holding tanks are empty. With the pump on, look for any points where the hose expansion differs, and inspect for obstructions at that location. Turn the Thetford Water Pump switch to the Off position. To check for a hose obstruction, visually inspect the hose for any foreign matter. To check for an obstruction in the impeller, look through the clear access cap on the pump. Note that fluid contents in the system may prevent visual inspection. Failure to clear a clog could cause damage to the pump, which will void the warranty.
General| Brand | Thetford |
|---|---|
| Model | Sani-Con Turbo |
| Category | Plumbing Product |
| Language | English |
Understand warnings, avoid modifications, and note company liability for improper use.
Wear appropriate protective gear when using the Sani-Con system.
Flush only organic waste and toilet tissue; avoid non-dissolving items.
Ensure garden hose has minimum 3/4 inch (1.9 cm) diameter to avoid pump failure.
Do not let the pump run dry, as this could damage the macerator.
Contact Customer Service for questions or assistance.
Diagram and list of components for the Sani-Con Turbo tank assembly.
Procedure for connecting the Sani-Con Turbo hose and nozzle to the dump station.
Step-by-step instructions for emptying the black water tank using the Sani-Con system.
Emptying black water first allows gray water to cleanse the system.
Instructions for emptying gray water tanks and repeating for secondary tanks.
Steps to drain and prepare the hose for storage after use.
Tips for emptying black water first, extending hoses, and proper storage.
Procedure for removing obstructions from the pump impeller housing.
Instructions for using the manual override connection for draining.
Steps to prepare the Sani-Con system for winter storage using antifreeze.
Troubleshooting steps for reduced or stopped waste discharge pressure.
Diagnosing why the pump runs but expels no liquid.
Checks to perform when the pump motor does not operate.
Guide on how to disassemble the system to check for lodged objects.
Information on warranty terms and how to contact customer service for issues.
List and descriptions of available service kits for the Sani-Con system.
How to obtain more information about Thetford products and customer support.
To Next Page
