Factory Reset
Setting Smart Blind
Press and hold the Set
"
□
"
button on the Smart Blind body for more than 5 seconds until the status of the
LED doesn't change. Then release the Set button, the LED will flash rapidly after 10 seconds indicating
that it is in pairing mode now.
Installation (Inside Mounting/Surface Mounting).
Note: If the width of window sill is less than 1.2 inches, please use surface mounting.
Inside Mountia.
1.
Min. ≥ 1.2"
6"
6"
4
According to the diagram, measure and mark the corresponding position. Then drill the holes.
Insert the plastic expansions bolt into the holes and then fasten the extension brackets with the
screws.
7891011121314
123
5
To Next Page