Select an effect type (sound effect) in effect mode. To activate the effect mode press the [EFX]
button. At that, the right point of the three-digit LED display lights up.
The device is equipped with five global effect types (chorus, flanger, phaser, delay, reverb),
that can be precisely tuned via its parameters.
1.
Press on the [DIAL/ENTER] knob to select a suitable effect type (1 … 5).
ð
The current ‘Effect number’ flashes in the LED display, but the sound is still
unchanged
2. Push again on the [DIAL/ENTER] button, to confirm the effect selection.
ð
Now the sound changes and the ‘Effect number’ stops flashing.
3. After effect selection you can turn the [DIAL/ENTER] control to adjust the effect intensity
from 0 to 9.
Press the [EFX] button again to toggle between the five sound effects.
4. To exit the effect mode, press the [PATCH] button.
Selecting an effect type
The functions of the device
hand-drum pad
18
To Next Page
Loading...
Need help?
General