Resetting to factory default settings will replace all stored user settings with the default set‐
tings for the device. ‘SENSE’ and ‘CURVE’ will be reset to their default values.
Proceed as follows:
1. Keep the [DIAL/ENTER] button pressed while switching the device on.
ð
The LED display shows the constantly flashing parameter: .
2. Press the [DIAL/ENTER] button again to confirm the resetting.
ð
The LED display shows the parameter now for about 2 seconds faster flashing. After
that, the parameter is shown in the normal display again (not flashing). That ends
the procedure.
Resetting to factory default set‐
tings
The functions of the device
Synth Drum
25
To Next Page
Loading...
