thomann the t.amp E-400 - Page 9

NOTICE!
Damage to the device due to high voltages!
The device can be damaged if it is operated with the incorrect voltage or if high voltage peaks occur. In the worst case, excess vol‐
tages can also cause a risk of injury and res. Make sure that the voltage specication on the device matches the local power grid
before plugging in the device. Only operate the device from professionally installed mains sockets that are protected by a residual
current circuit breaker (FI). As a precaution, disconnect the device from the power grid when storms are approaching or it the device
will not be used for a longer period.
NOTICE!
Interference with nearby electrical devices due to magnetic elds!
The device generates strong magnetic elds that can interfere with the function of poorly shielded devices. The magnetic elds are
strongest directly above and below the Power Amplier. You should therefore never place sensitive devices such as pre-ampliers,
radio transmission systems, or tape decks directly above or below the Power Amplier. When placing the Power Amplier in a rack,
you should place it at the bottom thereof, and place any other equipment at the top of the rack.
NOTICE!
Risk of re due to installation of a wrong fuse!
Using fuses of a dierent type than compatible with the device may cause a re and seriously damage the device. Only use fuses of
the same type. Observe the labelling on the device casing and the information in the "Technical data” chapter.
NOTICE!
Possible staining due to plasticiser in rubber feet!
The plasticiser contained in the rubber feet of this product may react with the coating of the oor and cause permanent dark stains
after some time. If necessary, use a suitable mat or felt slide to prevent direct contact between the device’s rubber feet and the oor.
Safety instructions
E-400, E-800, E-1200, E-1500
9
Power Amplier