page 8
Position assembled table frame in your desired location BEFORE
LEVELING the frame. Take a cue stick and hold the tip approximately 1"
in from the edge of the frame as shown.
Walk around the table with the cue stick to check the minimum distance
to any walls or objects to assure you have the minimum cue clearance to
play pool. If needed, move the table to a position that allow the best
playability.
FIG 3
Step 3 Table Location
& Cue Clearance
HECK ALL SIDES
To level the table you will find the Floor Guard TM leg leveler on the bottom
of each leg. Using the leg leveler wrench make sure that all four legs are
lowered to their lowest point by turning the wrench counter clockwise FIG
4.
Next, using the level provided, determine the highest corner of the frame
FIG 4A. Raise the three lower corners up to the level of the highest
corner with the leg leveler wrench, by turning it clockwise FIG 4B.
The table must be as level before installing the slate.
Counter
clockwise
Raise
Step 4
page 9
Table Leveling
Clockwise
Lower
To Next Page
Loading...