RZ RA RB
Model No.
TM
ERG4006 COMFORT CRIMP
®
COMPRESSION TOOL WITH SHURE STAKE
®
MECHANISM
For installing RZ Terminals, Splices (26-22 AWG Wire)
and RA, RB (.110) Disconnects (22-14 AWG Wire)
IMPORTANT:
Read and understand all of the instructions and safety
information in this manual before operating or servicing this tool.
RZ (22-26) NEST
In the event the SHURE STAKE
®
mechanism must be released, please see Figure 5.
TA04531 B Page 1 of 2
1. Open handles fully.
2. Insert terminal into proper
nest. Tongue markings
should face up.
3. Close the handles slightly
to secure the terminal.
Do not deform the
terminal.
4. Insert stripped wire.
5. Close handles until SHURE
STAKE
®
mechanism cycle
has been completed.
1.2
RA (22-18) NEST
Figure 3Figure 2
1.1
1.0
INSTRUCTIONS FOR USE
1. Open handles fully.
2. Rotate the locator down.
Insert terminal into locator.
3. Position terminal in proper
nest with terminal barrel
seam facing indentor
4. Close handles slightly to
secure terminal. Do not
deform terminal.
5. Insert stripped wire.
6.
Close handles until
the SHURE STAKE
®
mechanism cycle has
been completed.
For use with RA and RB (.110)
Insulated Disconnects 22-14 AWG
WARNING
HANDLES ARE NON-INSULATING.
DO NOT CRIMP ON HOT ENERGIZED WIRES.
WARNING
KEEP ALL BODY PARTS AWAY FROM DIE NEST
DURING GAGING OR CRIMPING PROCEDURE.
Figure 1
RB (16-14) NEST
For use with RZ Insulated Terminals
and Splices 26-22 AWG
To Next Page
Need help?
General
