Figure 1
1.1
1.2
1.3
*See Gaging Table
on Page 2
IMPORTANT: Read and understand all of the instructions and safety information in this manual
before operating or servicing this tool.
COMFORT CRIMP
®
ERG2001/ERG2003/ERG2007/ERG1255/ERG2006
SHURE STAKE
®
TOOL
CALIBRATION VERIFICATION
TA01224 C Page 1 of 2
WARNING
HANDLES ARE NON-INSULATING.
DO NOT CRIMP ON HOT ENERGIZED WIRES.
1.0
INSTRUCTIONS FOR USE
SHURE STAKE
®
Mechanism
In the event the SHURE STAKE
®
MECHANISM must be released, please see Figure 2.
Figure 2
WARNING
KEEP ALL BODY PARTS AWAY FROM DIE
NEST DURING GAGING OR CRIMPING
PROCEDURE.
Maintenance
1. Remove dust, moisture, and other contaminants with
a clean brush or a soft, lint-free cloth.
2. DO NOT use on objects that could damage the tool.
3. Make certain all pins, pivot points, and bearing
surfaces are protected with a THIN coat of any good
SAE No. 20 motor oil. DO NOT oil excessively.
4. Keep handles closed when not in use to prevent
objects from becoming lodged in the crimping dies.
5. Store tool in a cool, dry area.
SHURE STAKE
®
Mechanism Check
1. Squeeze handles until jaws are fully closed but before
SHURE STAKE
®
mechanism releases.
2. Apply a force gradually at 1-1/2” from end of handles
until SHURE STAKE
®
mechanism relases, see Figure 2.
3. The force required to release the SHURE STAKE
®
mechanism should be 35 lbs minimum, 45 lbs.
maximum.
1-1/2
To release the SHURE STAKE
®
mechanism, push up on the
release bar until the ratchet
teeth are disengaged.
To Next Page
Need help?
General
