Why is the suction power on my Thomas Vacuum Cleaner insufficient?
If your Thomas Vacuum Cleaner's suction power is weak, try these steps: * Clean the special hygiene filter. * Disassemble and clean any nozzles, suction pipes, or hoses that may be blocked. * Ensure the electronic suction power control isn't set to MIN; adjust it to MAX. * Close the sliding button on the handle if the mechanical suction power control is open.
How to fix suction power gradually decreases in Thomas PET & FAMILY Aqua+?
If your Thomas Vacuum Cleaner's suction power is gradually decreasing, try the following: 1. Clean the special hygiene filter. 2. Stretch the hose during operation to loosen any blockages, and then remove the blockage. 3. Ensure the housing cover is properly shut.
How to troubleshoot a Thomas PET & FAMILY Aqua+ that will not start?
If your Thomas Vacuum Cleaner won't start, check the following: * Ensure the power cord, plug, and socket are intact. * Make sure the appliance is switched on. Remember to unplug the power cord before checking it, and have any repairs done by authorized specialists.
Why does dust come out of my Thomas PET & FAMILY Aqua+ while vacuuming?
If dust comes out of your Thomas Vacuum Cleaner during vacuuming, ensure the aqua filter system is fitted correctly as described in the user manual and that there is enough water in the waste water tank.
What to do if cleaning fluid doesn't come out of Thomas Vacuum Cleaner?
If no cleaning fluid comes out of your Thomas Vacuum Cleaner even when the pump is on: * Ensure the spray solution tank is filled with cleaning fluid. * If the spray nozzle is clogged, place it in lukewarm water for a while, and then blow it out. * If the tank connection duct is clogged, remove the fresh water tank and use the crevice nozzle to thoroughly vacuum any dirt from the tank connection duct.
Why does my Thomas PET & FAMILY Aqua+ turn off during operation?
If your Thomas Vacuum Cleaner switches off during operation: * Empty the waste water tank, as it may be full. * Ensure the appliance is on a level surface. If it was tilted or suddenly turned, place it in a level position and switch it on.
Why are there water droplets inside the Thomas PET & FAMILY Aqua+ housing cover?
If you notice numerous water droplets on the inside of the housing cover of your Thomas Vacuum Cleaner: * Clean the aqua filter system and change the water if there is too much dust in it. * Hold the floor spray nozzle slightly more upright while vacuuming if it's not lying correctly on the floor. * Remove the wet vacuuming insert for normal vacuuming and fill the aqua filter box with 1L of water if the wet vacuuming insert has been inserted into the aqua filter box.
Why is water coming out of the exhaust openings of my Thomas PET & FAMILY Aqua+ Vacuum Cleaner?
If water comes out of the exhaust openings of your Thomas Vacuum Cleaner, the float in the waste water tank may be dirty and stuck. Clean the float and the tank.
How to prevent excessive foaming in the Thomas Vacuum Cleaner waste water tank?
If you see excessive foaming in the waste water tank of your Thomas Vacuum Cleaner, replace your current cleaning solution with genuine THOMAS cleaning concentrate.
What to do if water pools in the suction chamber of Thomas PET & FAMILY Aqua+ Vacuum Cleaner?
If an excessive pool of water collects in the suction chamber of your Thomas Vacuum Cleaner (note that a few drops are normal), clean the gaskets and seal faces if they are very dirty. Also, check if you forgot to put in the spray extraction insert.
Alerts users against operating the appliance in environments with a risk of explosion.
Essential safety guidelines for operating the appliance safely.
Specific safety advice for using the spray extraction and wet vacuuming functions.
Instructions for preparing the appliance for dry vacuuming using the aqua filter.
Instructions for preparing the appliance for dry vacuuming using the filter bag.
Steps for switching on, selecting power levels, and adjusting suction power.
Preparing the appliance and starting the spray extraction cleaning process.
Solutions for common problems encountered during general use and dry vacuuming.
Solutions for problems related to spray extraction and wet vacuuming operations.
General| Type | Wet and dry vacuum cleaner |
|---|---|
| Power Consumption | 1700 W |
| Noise Level | 81 dB |
| Corded/Cordless | Corded |
| Water Filter | Yes |
| Water Filter Capacity | 1.8 liters |
| Cable Length | 8 m |
| Special Features | Aqua+ |
| Dust Capacity | 1.8 liters (water filter) |
To Next Page