THOMSON CT350 - Installation

USE
INSTALLATION
• Plug the mains adaptor into the DC IN socket.
• Insert the mains adaptor plug in the power connector at the back of the device.
• The time will be shown at standby mode and TIME at 0.00.
SETTING THE TIME AND DATE
• Press CLOCK SET button on at standby mode in 2 second to enter the clock setting
• The hours display flashes the (clock set)
• Turn the TUNING wheel to set the hours
• Then press CLOCK SET to set a minutes
• Repeat above steps to set a minutes / year / month / day
ALARM SETTING
ALARM 1 and ALARM 2 settings
The device has 2 different alarms that can be set on different modes (BUZZ, RADIO, WEEK and
WEEKEND).
• Press ALARM 1 button on at standby mode in 2 second to enter the alarm setting
• The hours display flashes
• Turn the TUNING wheel to set the hours
• Then press ALARM 1 to set a minutes
• Turn the TUNING wheel to set the minutes
• Press ALARM 1 to set a wake by Buzzer “Zzz” or wake by Radio
ACTIVATING AND SELECTING ALARM1 OR ALARM2 MODE
• Press or repeatedly to select the type of alarm function:
• Press to activate an alarm, the alarm time will be shown on display
• With a week icon the alarm rings week date
• Without a week icon the alarm rings everyday
DEACTIVATING THE ALARM
• To deactivate alarm 1 or alarm 2, press or repeatedly until the alarm lights turn off.
ALARM REPEAT (SNOOZE)
• Touch or pass your hand over the SNOOZE SENSOR proximity sensor to stop the alarm. The alarm will
sound every 9 minutes. The word SNOOZE flashes intermittently until the alarm sounds again.